STM32G431 USB dfu , CAN bus , PB8 and nSWBOOT0 The problem is that the transceiver will set the RX pin high at boot , this will put the G431 in boot mode and never start . The question is how to set and reset the nSWBOOT0 bit in the program . I mean , if I am right ::2) at setup (yes , Arduino) , the nSWBOOT0 bit is set in order to disable BOOT0 pin , thus allow normal (CAN bus) operation after boot on PB8 .1) but this will reset the STM32 , so before doing 2) , one need to read the level of nSWBOOT0 , and only set it if it is 0 . (one time action)3) but this will brick the DFU uploading . To reset this , for exemple by a customer In order to update the firmware , one have to reset the nSWBOOT0 by the program . This could be done by a button , or by a code received trough USB .Hope this is clear enough (and correct of course) . But doing this is not that simple for me , so I wonder if there is a working code available for this (sure , some people have done the trick successfully ) ?Thank you !Edit : c
